Interfacing With The Software Driver - Analog Devices Advantiv EVAL-ADV7611EB1Z Evaluation Note

Eval Note

5.2.6 Interfacing with the Software Driver

Jumper K8, when inserted, pulls the microcontroller reset low. To use the software driver, please ensure
that K8 is removed.
To stop and start the software driver (e.g. to allow access to the I2C over XRC), toggle the SW_ENABLE
switch on the evaluation board. When disabled, the driver will send the message "REP: Driver Disabled".
When enabled, the driver will send the message "REP: Driver Enabled" and any status updates will be
displayed.
12. Please see the software driver documentation for the functions performed by software driver
buttons (S_UP, S_DOWN, S_LEFT, S_RIGHT, S_SELECT, S_BACK ) and LEDS (LED1, LED2,
LED3, LED4, LED5, LED6). To enable the software driver, switch the software enable switch (S10) to
SW_ENABLE. To disable the software driver, switch the software enable switch (S3) away from
SW_ENABLE.
For information on the latest software driver, please contact your FAE or email
ATV_VIDEORX_Apps@analog.com.
Rev. PrA Page 12 of 31