Troubleshooting - ETC ColorSource Spot jr v2.0 Installation Manual

ETC Installation Guide
ColorSource Spot jr v2.0/v3.0/v4.0
Adjust the Intensity of Presets
1. Ensure that DMX data is not present.
2. Press the Mode button to access the Presets/Sequences menu, and
then press the Up button or Down button to select the preset that
you want to edit.
3. Press and hold the Mode button for 3 seconds. The display shows
L:
followed by either an intensity level from
4. Press the Up button or Down button to change the intensity level of
the preset in real time.
5. Press the Mode button to confirm your selection and return to
the Presets/Sequences menu. (If you don't press the Mode button,
the display returns to the Presets menu after 10 seconds without
saving your changes.)

Troubleshooting

Update the Fixture Software
ETC recommends using UpdaterAtor software to manage software
updates. For information on UpdaterAtor, see the UpdaterAtor Software
Quick Guide and the UpdaterAtor Software Release Note , which you can
download from etcconnect.com.
You can push newer software versions from a connected fixture to
selected ColorSource fixtures (see table that follows).
Note:
not need to disconnect them before pushing the updated fixture
software. The update process will ignore any other fixture types in
the DMX run.
Note:
version number appears on the display when the fixture powers
up.
ColorSource Spot jr
If you have other types of fixtures in your DMX run, you do
Not sure what version of fixture software is installed? The
Page 10 of 16
0– 99 FL
or for full.
ETC