ETC ColorSource Spot jr v2.0 Installation Manual page 5

ETC Installation Guide
ColorSource Spot jr v2.0/v3.0/v4.0
Set Up the Fixture
1. Plug the power cord into the powerCON In connector on the rear of
the fixture.
2. Make any power-thru cable connections prior to applying a power
source.
3. Make any DMX connections, and if the fixture is the last in a DMX
line, terminate the fixture. See
4. Plug the power cord into the power source.
Power Up
Press any button to wake the display. The display shows the DMX
address. See
You can press the Mode button to access the Presets/Sequences menu.
Play Presets and Sequences on page 8
See
Adjust the Tilt
The fixture can be tilted up and down and rotated (panned) as needed.
1. Loosen, but do not remove the yoke locking knob.
2. Tilt the fixture to the desired angle.
3. Tighten the yoke locking knob.
ColorSource Spot jr
Set the DMX Address on the next page
Yoke
locking knob
Connectors on the previous page
.
Page 5 of 16
.
.
ETC