Troubleshooting; Restore Factory Defaults - ETC ColorSource PAR jr Installation Manual

ETC Installation Guide
ColorSource PAR jr

Troubleshooting

Update the Fixture Software
ETC recommends using UpdaterAtor software to manage software
updates. For information on UpdaterAtor, see the UpdaterAtor Software
Quick Guide and the UpdaterAtor Software Release Note , which you can
download from etcconnect.com.
You can push newer software versions from a connected fixture to other
ColorSource PAR jr fixtures of the same type.
Note:
not need to disconnect them before pushing the updated fixture
software. The update process will ignore any other fixture types in
the DMX run.
Note:
version number appears on the display when the fixture powers
up.
1. Remove power and DMX In from the fixture that is running the
software version that you want to push to other fixtures.
2. Press and hold the Up button and Down button simultaneously
while restoring power.
3. The display shows
selected.
4. Press the Mode button to start the update process.
• The first time that you push an updated software version,
• The display alternates between
• The display returns to its previous value (DMX address or active
5. Reconnect DMX In on the fixture.
Restore Factory Defaults
Press and hold the Mode button, Up button, and Down button sim-
ultaneously for 3 seconds. The DMX start address will blink once to con-
firm that defaults have been restored.
ColorSource PAR jr
If you have other types of fixtures in your DMX run, you do
Not sure what version of fixture software is installed? The
Udt rdy
additional required files must be copied before the update can
begin. The display alternates between
indicate the percentage complete while required data is
copied.
complete while updating the connected fixtures.
preset) to indicate that the update is complete.
to indicate the update mode is
Udt
and the percentage
Page 9 of 12
Udt c:XX
and to
ETC