Quick Reference - ETC ColorSource Spot jr v2.0 Installation Manual

ETC Installation Guide
ColorSource Spot jr v2.0/v3.0/v4.0

Quick Reference

DMX Control Channels
5ch
DMX
Channel
(5 channel)
1 Intensity
2 Red
3 Green
4 Blue
5 Strobe**
6
*Original ColorSource Spot jr fixture uses blue in channel 4; Deep Blue fixture uses indigo in
channel 4.
**Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase the strobe rate
from 1 per second up to 33 per second.
Error Codes
These error codes may display on the user interface.
• CAL
with the color calibration. The fixture will need to be returned to
the ETC factory; contact your local dealer to set up a repair.
• OtP
fixture has gone into over-temperature protection mode to avoid
damaging the fixture. Once the fixture has self-cooled, the error
will automatically clear. If the error does not clear, contact
ETC Technical Support (visit etcconnect.com/contactETC).
• No App
upgraded fixtures have a software issue. Reload software to clear
the error. If the error persists, contact ETC Technical Support (visit
etcconnect.com/contactETC).
ColorSource Spot jr
dir
(Direct)
Intensity
Red
Green
Blue/Indigo*
Lime
Strobe**
: Screen toggles between
: Screen toggles between
: Screen toggles between
1ch
(1 Channel)
Intensity
CAL Err
and
OtP Err
and
no
and
Page 16 of 16
rgb
(RGB)
Red
Green
Blue
to indicate a problem
to indicate that the
APP
to indicate that the
ETC