ETC ColorSource Spot jr v2.0 Installation Manual page 7

ETC Installation Guide
ColorSource Spot jr v2.0/v3.0/v4.0
Change the DMX Control Mode
You can set the DMX control mode for the fixture to one of four available
mode options.
1. Press any button to wake the display. The display shows the DMX
address.
2. Press and hold the Mode button for 3 seconds. The display shows
the current DMX control mode.
3. Press the Up button or Down button to change the DMX control
mode. (The currently saved mode is indicated by a decimal point at
the end of the mode name.)
•
•
•
•
4. Press the Mode button to confirm your selection.
The display will automatically return to the DMX address after 10 seconds
of inactivity, and edits to the DMX control mode will not be saved. This
cancels unsaved changes.
DMX Control Channels
5ch
DMX
Channel
(5 channel)
1 Intensity
2 Red
3 Green
4 Blue
5 Strobe**
6
*Original ColorSource Spot jr fixture uses blue in channel 4; Deep Blue fixture uses indigo in
channel 4.
**Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase the strobe rate
from 1 per second up to 33 per second.
ColorSource Spot jr
5ch
: 5-channel mode (intensity, red, green, blue, and strobe).
This is the default mode.
dir
: Direct emitter control (intensity, red, green, blue/indigo,
lime, and strobe).
1ch
: 1-channel mode controls the intensity of preset 1
(defaults to 3200 K White).
rgb
: RGB mode (red, green, and blue).
dir
(Direct)
Intensity
Red
Green
Blue/Indigo*
Lime
Strobe**
1ch
(1 Channel)
Intensity
Page 7 of 16
rgb
(RGB)
Red
Green
Blue
ETC