Advertisement
ETC Installation Guide
ColorSource CYC v1.7/v3.1
Troubleshooting and Maintenance
Update the Fixture Software
ETC recommends using UpdaterAtor software to manage software
updates. For information on UpdaterAtor, see the UpdaterAtor
Software Quick Guide and the UpdaterAtor Software Release Note ,
which you can download from etcconnect.com.
You can push newer software versions from a connected fixture to
selected ColorSource fixtures (see table that follows).
Note:
do not need to disconnect them before pushing the updated
fixture software. The update process will ignore any other fixture
types in the DMX run.
Note:
installed? The version number appears on the display when the
fixture powers up.
This fixture...
CYC v1.7 or earlier
CYC v3.1
Linear v1.7 or
earlier
PAR v1.7 or earlier
PAR v3.0
Spot v1.7 or earlier
Spot v3.0
Spot jr v2.0
Spot jr v3.0
1. Remove power and DMX In from the fixture that is running the
software version that you want to push to other fixtures.
2. Press and hold the Up button and Down button simultaneously
while restoring power.
3. The display shows
selected.
ColorSource CYC
If you have other types of fixtures in your DMX run, you
Not sure what version of fixture software is
...can push software to these fixtures/releases when connected
CYC
≤ v1.7 v3.1 ≤ v1.7 ≤ v1.7 v3.0 ≤ v1.7 v3.0
X
X
X
X
X
Udt rdy
Linear
PAR
X
X
X
X
X
X
X
X
X
X
to indicate the update mode is
Page 9 of 12
Spot
Spot jr
v2.0
X
X
X
X
X
X
X
v3.0
X
ETC
Advertisement
