Table of Contents
Advertisement
ETC Installation Guide
ColorSource Spot jr v2.0/v3.0/v4.0
Installation
Mounting
The ColorSource Spot jr ships with a standard yoke for mounting with a
clamp. You can adjust the position of the yoke when necessary for low-
clearance mounting. Mount the ColorSourceSpot jr in an orientation
where the knobs are on the bottom. (This ensures that the accessory slot
is oriented correctly, and ensures ease of movement for the Zoom knob
and Focus knob.)
Standard yoke position
Safety Cable
A safety cable (or other approved
safety device) must be attached to
the fixture. The attachment loop is
on the rear of the fixture. Leave as
little slack as possible in the safety
cable to avoid catching the yoke of
the fixture.
Connectors
• Power: Two powerCON
• Data (DMX512/RDM): Two five-pin XLR connectors for data in and
thru
Note:
terminate the last fixture in line with a 120 Ohm resistor. To
purchase a terminator, please contact ETC customer service and
request part number SGE1507 (XLR terminator).
ColorSource Spot jr
The ColorSource Spot jr is not self terminating. You must
®
connectors for power in and thru
Page 4 of 16
Low-clearance yoke position
Safety cable
attachment loop
ETC
Advertisement
Table of Contents
Need help?
Do you have a question about the ColorSource Spot jr v2.0 and is the answer not in the manual?
Questions and answers