Signal Inputs And Outputs; Rear Connection Panel; Vga (Input 1); Hdmi (Input 2) - Digital Projection Titan Pro Series III User Manual

Digital Projection
Titan Pro series III

Signal Inputs and Outputs

Rear Connection Panel

VGA (input 1)

•
Use in the
Auto Setup Input Settings/Picture/VGA Setup
see the Operating Guide.

HDMI (input 2)

•
For settings, see the Operating Guide.

DVI (input 3)

Analog or Digital DVI-I
•
Set DVI-I Port in the Global Settings/Input Configuration
Analog and Digital . For more settings, see the Operating Guide.

SPDIF

•
Compatible audio sample packets on the HDMI input stream are decoded by the
projector and output on the SPDIF connector. This is a digital output.
3G-SDI (input 4)
•
If two video streams are being transmitted, set
Configuration menu to choose between the two streams.

CVBS1 (Composite video BNC) (input 5)

S-Video (input 6)

Component (input 7)

RGsB or RGBS
•
Set Component Colour Space in the
RGB .
•
Set to
Component Sync Type Auto
between (RGsB) and
3 Wire 4 Wire
YPbPr
•
Set in the
Component Colour Space
YPbPr .

CVBS2 (Composite video RCA phono) (input 8)

Rev A May 2012
SIGNAL INPUTS AND OUTPUTS
menu. For more settings,
menu to choose between
in the
3G Level B Stream
Global Settings/Input Configuration
, except when the projector has problems selecting
(RGBS).
Global Settings/Input Configuration
Input
menu to
menu to
Notes
For a complete listing of pin
configurations for all signal and
control connectors, see Wiring
Details later in this Guide.
See the next page for important
information about the differences
between the two connection panels.
Component (Input 7)
DVI (Input 3)
VGA (Input 1)
HDMI (Input 2)
SPDIF
CVBS1 (Input 5)
CVBS2 (Input 8)
S-Video (Input 6)
3G-SDI (Input 4)
Rear Connection Panel
Connection Guide
Page Conn_1