Positioning The Screen And Projector; Tilting The Projector; Chassis Adjustment - Digital Projection Titan Pro Series III User Manual

Digital Projection
Titan Pro series III

Positioning the Screen and Projector

•
Install the screen, ensuring that it is in the best position for viewing by your audience.
•
Position the projector, ensuring that it is at a suitable distance from the screen for the image to fill the screen.

Tilting the Projector

Do not tilt the projector more than is shown in the tilt diagrams, when in use, as this may cause serious lamp failure, damage the
lamp module and cause extra cost on replacement.
±10°
180°
SX+ 3D-L
1080p 3D-L
WUXGA 3D-L
SX+ 3D-P
1080p 3D-P
WUXGA 3D-P

Chassis adjustment

•
If the projector is to be operated from a flat surface such as a projector table, then
adjustment of projector level should be made by turning the four feet under the chassis.
Set the adjustable feet so that the projector is level, and perpendicular to the sceen.
Rev A May 2012
POSITIONING THE SCREEN AND PROJECTOR
±10°
±10°
SX+ 660
1080p 660
180°
WUXGA 660
±10°
Installation and Quick-Start Guide
Notes
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
Ensure that there is at least
30cm (12in) of space between the
ventilation outlets and any wall,
and 10cm (4in) on all other sides.
Do not place the projector with its
front panel down on a surface, as
this may damage the lens or the
lens release lever.
Page Inst_5