Table of Contents
Advertisement
Digital Projection
Titan Pro series III
A Tour of the Menus
Main Menu
Input Selection
•
Select an input source from the drop-down list.
Test Pattern
•
Set
to
Input Selection
Test Pattern
Global Settings
Global Settings are those that affect the whole projector, regardless of which input is being used or what kind of image is being displayed.
More information about this menu can be found later in this section.
Input Settings
The Input Settings are those that affect ONLY the input being displayed. When a new input mode (video or graphics standard) is detected, eg
NTSC, HDTV 1080p or SVGA, these settings are saved so that they can be recalled next time that input mode is displayed. In some cases
the mode may change for the same input. For example, a DVD player connected to the HDMI input could switch between 1080p24 and
1080i60. The projector is able to save and automatically recall different input settings for these different input modes.
More information about this menu can be found later in this section.
System
The System menu allows you to open and close the shutter, and to switch the power off and on.
More information about this menu can be found later in this section.
Information
Information about the projector, the current input source, and about Digital Projection.
More information about this menu can be found later in this section.
Rev A May 2012
, then select a test pattern from the drop-down list.
A TOUR OF THE MENUS
Operating Guide
Notes
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
Main Menu
You can also select an input source
by pressing
to
or
(dual pipe) on the remote control.
The Test Pattern menu is not
available until
is
Test Pattern
selected from the
Input Selection
drop-down list.
Test Patterns are subject to image
controls, so brightness, contrast
etc. will affect their appearance on
screen.
Page Op_5
Advertisement
Chapters
Table of Contents
