IHI IC75-2 Operation Manual page 70

Slope Warning
Slope alarm mark (1) is displayed and blinks on the
display if the machine inclines forward by 9° or more
when it is descending on a slope.
At the same time, the buzzer sounds for five seconds.
On a slope of an angle over 9°, set the travel speed select
switch (2) to the Low position.
In the manual mode, travel straight on a hilly road with
engine revolutions of medium speed or lower.
If the machine travels without dropping the speed, there is
a danger of overrun.
Overrun avoidance operation
Carry out the following operations immediately to reduce
the speed:
1. Return the joystick lever to the neutral position.
2. Reduce the engine speed control dial (3) down to the
low speed.
The cause of overrun is over-loading. Never over-
load the machine.
Emergency Engine Stop Switch
The engine can be stopped forcibly by pressing the
emergency engine stop switch (4).
When the emergency engine stop switch is
•
pressed while traveling, the machine stops
immediately as the travel driving unit is locked.
When using the emergency engine stop switch,
be prepared for shock to your body.
• Avoid using the emergency engine stop switch
while traveling at high speed.
Otherwise, it will not only cause the machine to
turn over and/or malfunction, but also become
dangerous to the operator.
IC75-2 ENG
OPERATION
3-18
The posture at which the safety
warning devices are activated