Long Term Storage - IHI IC75-2 Operation Manual

LONG TERM STORAGE

Before Storage
Move the vessel down to the lowest position while
storing in order to protect the cylinder rod from rust.
To store the machine from long term, follow the next
procedures.
1. Clean parts of the machine.
2. Be sure to perform fill the fuel, lubrication, and oil
change.
3. Select a well-drained, dry and well-ventilated flat place.
Put plates on the ground.
4. Store the battery after remove the negative terminal
and covering it or dismounting the battery from the
machine.
During Storage
If you have to operate the machine indoors to
prevent rust, keep good ventilation and gas
poisoning by window or entrance.
1. During storage, operate the machine once a month to
maintain films of oil at the lubrication section and
charge the battery at the same time.
2. Before starting the engine, always crank the engine
with the starter and check that the engine oil pressure
warning lamp is OFF on the Trouble Code display.
3. After starting the engine, let it idle for about 5 minutes.
After Storage
Before using the machine after long-term storage,
lubricate or grease every necessary parts, check the
coolant and DEF levels, and replenish them if necessary,
IC75-2 ENG
MAINTENANCE
NOTICE
4-34
Position for long term
storage