Stopping The Engine - IHI IC75-2 Operation Manual

STOPPING THE ENGINE

• Be sure to move down the vessel, stop the
engine and pull out the key before leaving the
operator seat.
Do not park the machine on a slope. If it is
•
necessary to park on a slope, use buffers on the
lower side of the crawler.
Stopping the machine
1. Stop the machine on a flat and rigid ground.
2. Set the parking switch (1) to the brake ON position.
3. Make sure that the vessel is lowered completely.
4. Check if the left lever unit (2) is set to the lock position.
Stopping the engine
1. Keep the engine idling for approximately 5 minutes to
lower the temperature of the engine.
2. Set the engine key switch (3) to the OFF position to
stop the engine.
3. Pull out the key from the engine key switch.
Inspection and locking after stopping the engine
1. Check necessary parts for oil leak and damages.
Repair defective parts if oil leak or damages are found.
2. Fill the fuel tank with fuel and urea aqueous solution.
3. Remove soil and sand from the vessel and traveling
mechanisms, in particular.
4. Lock the fuel filling port, engine hood and all other
lockable parts.
IC75-2 ENG
OPERATION
Operation position
3-16
Lock position
(Not used)