Am Radio (Option) - IHI IC75-2 Operation Manual

AM RADIO (OPTION)

• If water enters the speaker case and/or the radio, unexpected accidents may occur,
so be careful not to expose these units to water. Close the windows especially when
raining and washing the machine.
• Do not wipe the scale panel and the knobs with benzene, thinner and similar solvent.
• Wipe with a soft dry cloth.
• Do not disassemble the radio.
Power switch/VOL control
①
When this knob is rotated clockwise, you will hear a clicking
sound and the power is turned ON. Rotating this knob further
clockwise adjusts the speaker volume.
TONE control knob
②
Rotating this know clockwise emphasizes high-pitched tone.
Rotating this know counterclockwise attenuates high-pitched
tone.
Display
③
The clock, radio reception frequency and operation mode are
displayed.
CLK (clock button)
④
Pressing this button changes the display to show the clock.
Pressing it one more time shows the frequency.
AST
⑤
Pressing this button calls up preset stations in sequence. Press
this button again when the desired broadcasting station
appears on the display; the station display stops. When this
button is held down for the duration of 2 seconds, auto memory
is activated.
Preset buttons
⑥
One AM station can be preset to each button. (For the preset
procedure, see the item on "How to Preset.")
Seek
⑦
When the SEEK switch is pressed, songs that can be received
will automatically be sought and the seeking will stop when a
song is received.
Tuning buttons
⑧
When the tuning ▲ button is pressed, the broadcasting station
frequency increases. Pressing the ▼ button lowers the
frequency. When this button is held down continuously,
frequencies change in succession.
To listen to the radio
(1) Turn ON the starter switch to turn ON the power to the
radio.
(2) Select a station using the preset buttons or the tuning
buttons.
(3) Adjust the volume and sound quality as desired.
• Be sure to listen to the radio at an appropriate volume
level in order to secure safe operation.
(4) To turn OFF the radio, rotate the VOL know
counterclockwise until you hear a clicking sound.
Regarding seek (automatic) station selection
IC75-2 ENG
CONTROLS
When the SEEK switch is pressed, station selection
starts toward higher frequency broadcasting stations.
When a receivable broadcasting station is sought, the
seeking stops automatically.
Regarding manual station selection
When the tuning ▲ button is pressed, the broadcasting
station frequency increases; when the tuning ▼ button
is pressed, the broadcasting station frequency
decreases. When this button is held down continuously,
frequencies change in succession.
To preset broadcasting stations
(1) Select a station you want to preset.
Select the frequency of that broadcasting station with
the tuning buttons.
(2) When you hold down the button to which you want to
preset the broadcasting station for 2 seconds, the same
number as that of the button appears on the display and
preset completes.
● To store another broadcasting station to an already
preset switch, repeat steps (1) and (2) above.
● If the power is turned OFF for battery change, for
example, the preset settings will be erased. In such
a case, preset again.
● A total of six AM (MW) stations can be stored.
Regarding auto memory
When the AST button is held down for 2 seconds,
broadcasting stations that are receivable at the current
location are called up in sequence and they are
automatically stored in the preset memory.
To set the clock (see the figure below)
(1) Turn ON the starter switch to turn ON the power to the
radio.
If the display shows the frequency, press the CLK button
to change to the clock display.
(2) Pressing the ▼ button while holding down the CLK
button sets the hour and the ▲ button sets the minute.
2-28
While holding
down
Minute
adjustment
Hour
adjustment