IHI IC75-2 Operation Manual page 50

Operating Procedure
To start and stop the air conditioner
Press the power switch.
To cool
① Press the A/C switch.
② Using the TEMP switches, set the
temperature setting to
screen.
③ Using the airflow switches, select the
desired airflow.
④ Using the MODE switch, select Vent
as the air outlet position. (It is the
recommended position, but you can
change Vent as desired.)
⑤ Using the R/F switch, select Recycle
(recommended setting).
If it gets too cold, raise the temperature with
the TEMP Up switch, decrease the airflow
with the Lo airflow switch, or adjust to the
desired temperature using both.
• When the A/C switch is not pressed, air
conditioning does not take effect and the
air ventilation mode is automatically set.
• When Vent is selected as the air outlet, air
also blows out of the face vents.
• While clearing condensation on the front
glass, do not set the temperature close to
the maximum cooling temperature.
• If cool air blows onto the front glass, the
outside of the front glass may condensate,
interfering with visibility.
To heat
① Using the TEMP switches, set the
temperature setting to
screen.
② Using the airflow switches, select the
desired airflow.
③ Using the MODE switch, select Foot
as the air outlet. (It is the recommended
position, but you can change the foot
position as desired.)
IC75-2 ENG
CONTROLS
④ Using the R/F switch, select Recycle
If it gets too hot, lower the temperature with
the TEMP Down switch, decrease the airflow
with the Lo airflow switch, or adjust to the
desired temperature using both.
on the LCD
• When the A/C switch is pressed,
• When Foot is selected as the air outlet, air
To thaw frost from the front glass
① Using the TEMP switches, set the
② Using the airflow switches, select the
③ Using the DEF switch, set the air outlet as
④ Using the R/F switch, select Recycle
• By pressing the MODE switch, the setting
• When DEF is selected as the air outlet, air
To clear condensation on the front glass
① Using the airflow switches, select the
② Using the DEF switch, set the air outlet as
③ Using the R/F switch, select Fresh Air
on the LCD
• To quickly clear condensation, select the
• By pressing the MODE switch, the setting
2-27
(recommended setting).
dehumidification heating takes effect.
also blows out of the defroster.
temperature setting to
screen.
desired airflow.
the defroster .
before the DEF switch was pressed is
restored.
also blows out of the foot vents.
desired airflow.
the defroster .
maximum airflow using the Hi airflow
switch.
before the DEF switch was pressed is
restored.
on the LCD
.
.