Assembly; Mounting Position; Fit Handwheel; Mount Actuator To Valve - AUMA SAEx 07.2 Operation Instructions Manual

5 Assembly

5.1 Mounting position

5.2 Fit handwheel

How to proceed 1. If required, fit spacer [1] on input shaft [2].

5.3 Mount actuator to valve

NOTICE
When using grease as lubricant, the product described herein can be operated in any
mounting position.
When using oil instead of grease within the actuator gear housing, perpendicular
mounting position is specified whereby the flange is pointing downward. The type of
lubricant used is indicated on the actuator name plate (short designation F...= grease;
O...= oil).
To avoid transport damage, handwheels are supplied separately as appropriate. In
this instance, the handwheel must be mounted prior to commissioning.
Figure 8: Handwheel
[2]
[1] Spacer
[3] Handwheel
2. Slip handwheel [3] onto input shaft.
3. Secure handwheel [3] with retaining ring [4].
Information: The retaining ring [4] (together with these operation instructions) is
stored in a weatherproof bag, which is attached to the device prior to delivery.
Corrosion due to damage to paint finish and condensation!
à Touch up damage to paint finish after work on the device.
à After mounting, connect the device immediately to electrical mains to ensure that
heater minimises condensation.
[1]
[2] Input shaft
[4] Retaining ring
Assembly
[3]
[4]
13