Assembly
5.3.3 Output drive types B/C/D/E
Short description Connection between hollow shaft and valve or gearbox via output drive sleeve fixed to
18
Figure 15: Mounting principle
[1]
[2]
B1
B2
B
[1]
Flange multi-turn actuator (e.g. F07)
[3]
Output drive sleeve (illustration ex-
amples)
the hollow shaft of the multi-turn actuator via retaining ring.
When exchanging the output drive sleeve, later retrofitting to a different output drive
type is possible.
•
Output drive type B/E:
Output drive sleeve with bore according to DIN 3210
•
Output drive types B1/B3:
Output drive sleeve with bore according to EN ISO 5210
•
Output drive types B2/B4:
Output drive sleeve with bore according to customer order
B4 including special bores like bores without keyway, square bore, hexagon bore,
internal splines
•
Output drive type C:
Output drive sleeve with dog coupling according to EN ISO 5210 or DIN 3338
•
Output drive type D:
Shaft end with key according to EN ISO 5210 or DIN 3210
Spigot at valve flanges should be loose fit.
[3]
B3
B4
C
E
[4]
[2]
[4]
D
Hollow shaft
Gearbox/valve shaft