Grease Filter Switch - Broaster VF-2 Service & Parts Manual

4. Raise Element Arm (42) and set it in
Element Retainer (43). Check across
wire leads (40). Meter should indicate
an open circuit. If not, switch is faulty.
VF3i Element Up Switch Replacement:
1. See Access For Service
2. Loosen nuts (41) and slide switch
down out of bracket.
3. Disconnect switch lead wires (40) if not
already disconnected.
4. Reassemble in reverse order making
sure lead end of switch is flush with
bottom of bracket.
VF3i Grease Filter Switch:
The grease filter switch is located in the
cooking area on the right side of the filter
tray inside boot (44).
The leads for this switch are in the electrical
control compartment.
44
broaster.com Manual #16501 7/06 rev 2/15
1. See Access For Service.
2. Disconnect switch leads (45). Check
across wire lead. Meter should indi-
cate a closed circuit. If not switch is
faulty.
45
3. Unlatch Filter Tray (32) and remove
from cooking compartment. Check
across wire leads (45). Meter should
indicate an open circuit. If not, switch
is faulty.
5-10
Grease Filter Switch is
mounted in this fitting.
45
32