Temperature Sensor Probe - Broaster VF-2 Service & Parts Manual

TEMPERATURE SENSOR PROBE

This probe is a thermocouple. It sends fluc-
tuating millivolts to the controller which
translates them into degrees of tempera-
ture.
1. See ELEMENT SHAFT REMOVAL
2. Remove Connector Box Cover (19) by
removing screw (20).
3. Remove screw (21) from probe retainer
(22).
4. Remove nut (23).
5. Carefully pull probe (24) out of Con-
nector Box. DO NOT allow wires being
pulled out of Element Shaft to damage
any of the remaining components.
6. Install new probe in the same location
as old probe. End of probe sheath
should be 1/8" above nut (23) when
installed properly.
19
20
21 24
22
broaster.com Manual #16501 7/06 Rev 2/15
Temperature Regulating Probe
7. Tighten nut (2)
8. Carefully thread wires through Element
Shaft.
9. Reassemble element shaft by revers-
ing the ELEMENT SHAFT REMOVAL
instructions.
10. See Calibration in Section 3 of this
manual.
11. Run one cycle to check for proper
function.
4-3
24
23