Broaster VF-2 Service & Parts Manual page 64

VF3i Access Door Switch
The Access Door Switch (37) is located in
the upper left corner of the electrical control
compartment.
37
1. Disconnect both switch wire leads
(38).
2. With Access Door open, check across
wire leads (38). Meter should indicate
an open circuit. If not, switch is faulty.
3. With Access Door closed, check
across wire leads (38). Meter should
indicate a closed circuit. If not, switch
is faulty.
VF3i Access Door Switch Replacement:
The Access Door Switch (37) is located in
the upper left corner of the electrical control
compartment.
1. Loosen the hex nuts and slide switch
out of bracket.
2. Disconnect lead wires (38) if not
already disconnected.
3. Reassemble in reverse order making
sure end of switch is against the front
panel and slid fully into bracket.
VF3i Element Up Switch:
38
The Element Up Switch (39) is located in the
control compartment on the interior wall
below the Element Pivot Shaft (15).
5-9
broaster.com Manual #16501 7/06 rev 01/22
40
1. See Access For Service
2. Disconnect switch leads (40).
3. With the element in the down position
check across wire leads (40). Meter
should indicate a an open circuit. If
not, switch is faulty.
43
42
15
39
41