Broaster VF-2 Service & Parts Manual page 62

VF2 Access Door Switch Replacement:
The Access Door Switch (21) is located in
the upper area where the fan is mounted. To
access it remove the top cover.
1. Loosen hex nut and slide switch out of
bracket.
2. Disconnect switch lead wires (22) if not
already disconnected.
3. Reassemble in reverse order making
sure end of switch is against the front
panel and slid fully into the bracket.
VF2 Element Up Switch:
15
26
27
The Element Up Switch (25) is located in the
control compartment on the interior wall
below the element pivot shaft (15).
1. See Access For Service.
2. Disconnect switch leads (26).
3. With the Element in the down position,
check across the wire leads (26).
Meter should indicate an open circuit.
If not, switch is faulty.
25
broaster.com Manual #16501 7/06 rev 4/22
4. Raise Element Arm (28) and set it in
the Element Retainer (29), check
across wire leads (26). Meter should
indicate an open circuit. If not, switch
is faulty.
28
VF2 Element Up Switch Replacement:
1. See Access For Service.
2. Remove hex nuts (27) and slide switch
off of studs.
3. Disconnect switch lead wires (26) if not
already disconnected.
4. Reassemble in reverse order making
sure switch is mounted with the leads
pointed down.
5-7
29