Preset Cook Mode; Programming Procedure - Broaster VF-2 Service & Parts Manual

Response: Controller returns to idle
mode.
Set Time:
Action: Press Cook Time Button twice
within 5 seconds.
Response: Programming mode has
been entered. Flashing Time Display
reads "##:##." (##:## = time value ie:
08:00)
Action: If desired, press key pad num-
bers to change displayed value in min-
utes and seconds then press Cook
Time Button once to enter new value
into memory.
Response: Controller returns to idle
mode.
Reset Cycle Counter:
Action: Press Reset Button twice in 5
seconds.
Response: Display will return to a set-
ting of "00."
If counter is not reset
before reaching "99."
Upon the next cycle completion, the dis-
play will begin counting at "01."
Normal operating programming can be
done at any time without affecting presets.

PRESET COOK MODE

Choose Preset Cook Cycle:
Action: Press a button, 0 thru 9, corre-
sponding to the desired preset.
Response: The TIME display will show
"P__X", where X is the preset selected.
in ten seconds, the display will revert to
the previous display.
PROGRAMMING PROCEDURE (PRESET
MODE)
Change Cook Time:
play will revert back to both the TIME
and TEMP displays flashing.
2-3
broaster.com Manual #16501 8/06 Rev 10/20
If a button is not pressed
Action: Press the same button again,
Response: The TIME display will show
the preset time, the TEMP display will
show the preset set point, and the
temperature will now regulate to the
new set point.
Action: Press and hold the TIME and
TEMP buttons simultaneously for three
seconds.
Response: The TIME display and
TEMP display will begin flashing. The
CYCLE COUNT display will show "-0"
indicating that the preset #0 values are
displayed. The preset values for the
TIME and TEMP will be shown on the
display.
Action: Press the TIME button once.
Response: The TEMP display will turn
off and only the TIME display will flash.
Action: Key in the desired cook time
then press the TIME button to save the
new setting.
If a button is not pressed
in ten seconds, the dis-