Advertisement
Available languages
Available languages
ASSEMBLY STEP 1
HARDWARE FOR STEP 1
PART
TYPE
DESCRIPTION
A
UPRIGHT GUIDE BOLT
M8X1.25PX11L
B
MAST BOLT
M8X1.25PX80L
8.4X15.5X1.6T
C
FLAT WASHER
D
SPRING WASHER
8.2X15.4X2.0T
2
4
A
1
A
3
10
C
D
B
12
A
Cut the BANDING STRAPS (10) and lift the running
deck upward from the rear to remove all contents from
QTY
underneath the running deck.
2
B
Open HARDWARE FOR STEP 1.
8
C
Insert UPRIGHT GUIDE BOLT (A) into MAIN FRAME
8
BRACKET (1) and fully tighten.
8
NOTE: Do not fully tighten the following bolts until the
end of STEP 4.
7
D
Attach LEAD WIRE to bottom end of CONSOLE
CABLE (2). Pull LEAD WIRE through RIGHT CONSOLE
MAST (4). After pulling the wire through the mast, the
top of the CONSOLE CABLE (2) should be located at
the ATTACHMENT BRACKET (7).
4
E
Attach RIGHT CONSOLE MAST (4) to MAIN FRAME (3)
using 4 BOLTS (B), 4 FLAT WASHERS (C) AND
4 SPRING WASHERS (D). Feed the extra console cable
B
back into the upright mast.
D
C
NOTE: Be careful not to pinch the console cable
while attaching the right console mast.
10
F
Repeat STEP E on the LEFT SIDE.
A
C
B
D
ASSEMBLY STEP 2
HARDWARE FOR STEP 2
PART
TYPE
DESCRIPTION
E
BOLT
M6X1.0PX15L
E
5
4
4
QTY
4
NOTE: Do not fully tighten bolts until STEP
3.
Open HARDWARE FOR STEP 2.
A
B
Attach CROSS SUPPORT BAR (5) using holes on
UPRIGHT MASTS (4) with 4 BOLTS (E).
E
13
Advertisement
