Operating The Medview Camera Using The Wall-Mounted Control Panel - Dräger Polaris 600 Instructions For Use Manual

Operating the MedView camera using the wall-mounted control panel

For a Polaris 600 light with MedView camera, the
camera control area is on the right-hand side of the
shared wall-mounted control panel.
Switching the MedView camera on
A
B
C
D
 Press the key (A).
The status LED (B) lights up.
– After switch-on, the camera runs through an
initialization procedure. This procedure takes
about 15 seconds.
– The Automatic exposure and Autofocus
functions are activated by default.
– The camera can also be operated when the
Polaris 600 light is in standby mode.
Instructions for use Polaris 600
Switching the MedView camera off
A
B
C
D
 Press the key (A).
The camera is in standby mode.
The status LED (B) is not lit.
– The key does not disconnect the camera
from the mains power supply (camera in
standby mode).
Operation
59