Items Included; Setup Notes - Epson Equity 386SX PLUS Product Support Bulletin

ITEMS INCLUDED

Equity 386SX PLUS CPU with 1MB (soldered), power cord.
101 key enhanced keyboard (6-pin mini DIN).
User's manual, slip-sheet and warranty card.
One key, used for locking the top cover of the CPU.
Three drive cables:
Read/write floppy cable.
Read-only floppy cable, identified by heat shrink tubing located near the
connector that connects to the main board.
IDE Hard drive cable with connectors for two drives.

SETUP NOTES

Setup is only available on boot-up (RESET or warm boot), and only when in
'Administrator" mode (jumper J1 is set to "B"). When the computer completes
its power-on diagnostics, two beeps will occur (this is not a SETUP error) and
the following prompt will appear:
After 5 to 8 seconds if F10 is not pressed, the computer will continue to boot.
If F10 is pressed, the Setup screen will appear. Press the F7 key twice to save
and reboot. Refer to page 3 of this document for a listing of the setup options.
If in "User" mode (J1 set to "A"), one beep will occur, no F10 option will
appear, and the system will continue booting.
Differences in Setup between the standard Equity 386SX PLUS and the
diskless version include
Extended memory size can be specified (in 128K increments).
Diskette boot control. Choose "Disabled" to use the system as a
dedicated workstation network node. Choose "Enabled" if a diskette
drive is installed and you want to be able to boot the system from that
drive.
After Setup is run you may want to change jumper J1 to position A and lock
the computer cover with the key lock. This changes the operating mode to
user mode and protects the computer's configuration.
Press F10 to run Setup
the
following:
PSB No: S-0133
Page: 2 of 4