Installing/Removing Expansion Cards - Siemens SIMATIC IPC647E Operating Instructions Manual

Expanding and assigning parameters to the device
6.2 Expansion cards
6.2.3

Installing/removing expansion cards

Note
Card retainers are included with the device for expansion cards with a low height.
You can find information on the specification of the expansion cards under "Usable
expansion cards (Page 87)".
Requirement
● The bus frame has been removed as described in the section "Removing/installing the
bus frame (Page 87)".
● Screwdriver T10
● Diagonal cutter
● Retainer from the included accessory kit.
Only identical types of retainers may be used.
Latching retainers are available under article number A5E02719654.
Note
Mounting bracket for low expansion cards
To guarantee the stable installation of a low expansion card, you need an additional
mounting bracket for latching retainers. The mounting bracket may have to be removed
when you replace the low expansion card with a high one.
At very low cards the latching retainer can be stabilized by using a guide rail.
90
Operating Instructions, 11/2018, A5E45589180-AA
SIMATIC IPC647E