Removing And Installing Expansion Cards - Siemens SIMATIC IPC847D Operating Instructions Manual

6.4.2

Removing and installing expansion cards

Requirement
● The device is opened.
Procedure
1. Remove the retainer rod
2. Unscrew the slot cover
3. Insert the expansion card
4. Screw down the slot cover
5. Insert the retainer rod
6. Loosen the free card retainer
7. Screw the card retainer into place.
8. Close the device.
* To fasten expansion cards with low height, longer card retainers are included in the
accessories kit. Replace the card retainer at the required position on the retainer rod.
PCIe interfaces
The following types of PCIe interfaces are available:
● PCIe Gen 2, expansion cards of the PCIe type Gen 1 and Gen 2 are supported.
● PCIe Gen 3, expansion cards of the PCIe type Gen 1, Gen 2, Gen 3 and PEG are
Information about the assignment of PCI/PCIe slots is available in chapter "Bus board -
Layout and principle of operation (Page 154)".
Notes on the allocation of resources
Only two exclusive interrupts are available for PCI /PCIe expansion cards due to the large
functional scope of the motherboard. If the new expansion cards require additional exclusive
resources, you must disable certain motherboard functions. For information on allocated
resources, refer to the section System resources (Page 163). Information on disabling
motherboard functions is available in the BIOS description.
See also
Bus board (Page 154)
Interrupt assignment of the slot connectors on the bus board (Page 161)
SIMATIC IPC847D
Operating Instructions, 01/2014, A5E32997454-AA
slot.
slot.
expansion card again.
③
on the expansion card.
With short expansion cards, you can remove
the locking screw from the retainer and screw
it into the hole on the opposite side.
supported.
Expanding and assigning parameters to the device
③
.
①
of the planned
②
into the relevant
①
for the
again*.
④
and place it
6.4 Expansion cards
75