Chapter 5 Problem Solver; When A Message Is Displayed - Epson SureColor S30670 User Manual

Chapter 5
Problem Solver

When a Message is Displayed

If one of the following messages is displayed, read and follow the instructions below.
Messages
Prepare empty waste ink
bottle.
Ink Cartridge Error
Ink cartridge cannot be
recognized. Insert again or
replace ink cartridge.
Ink Cartridge Error
Ink cartridge cannot be
detected. Insert again or
replace ink cartridge.
Ink Cartridge Error
Replace cleaning
cartridge.
Ink Low
Warming Up
ZForce to start printing
Command Error
Check print settings on
RIP.
Unit Matching Error
Check combination of
Media Feeding Unit and
Auto Take-up Reel Unit.
Then restart printer.
Clogged nozzles
detected.
Cleaning recommended.
What to do
The waste ink bottle is getting full. Ready a new waste ink bottle. See
"Options and Consumable Products" on page 143.
❏ Remove and reinsert the ink cartridge. If the message persists,
insert a new ink cartridge (do not reinsert the ink cartridge that
caused the error). See "How to replace" on page 111.
❏ Condensation may have formed inside the cartridge. Leave it at
room temperature for at least four hours before installing the ink
cartridge. See "Notes on handling ink cartridges" on page 25.
❏ Remove and reinsert the cleaning cartridge. If the message
persists, insert a new cleaning cartridge (do not reinsert the
cleaning cartridge that caused the error). See "How to replace"
on page 111.
❏ Condensation may have formed inside the cartridge. Leave it at
room temperature for at least four hours before installing the
cleaning cartridge.
The ink is low. Ready a new ink cartridge. See "Options and
Consumable Products" on page 143.
One or more heaters is still being warmed to the specified
temperature. To start printing without waiting for the heater to warm
up, press the Z button.
Press W and select Job Cancel. Check that the installed software
RIP is compatible with the printer.
The standard media feeding unit is used only with the standard auto
take-up reel unit, the heavy roll media feeding unit only with the
heavy roll auto take-up reel unit. If you have mismatched the
feeding and take-up reel units, turn the printer off and install the
correct equipment.
See the Setup Guide and the Heavy Media Roll System Setup Guide.
Stop printing and perform head cleaning if you judge it necessary
on inspecting the print results. See "Head Cleaning" on page 87.
131
Problem Solver