Epson SureColor S30670 User Manual page 10

5 Roll core holder locking screw
The locking screws keep the roll core holders in place once they have been attached to the roll
core. There are two locking screws: one on the left and one on the right.
6 Roll support
Rest media temporarily on these supports when removing the take-up roll. There are two supports:
one on the left and one on the right.
7 Auto switch
Use this switch to select the auto take-up direction. Choose Off to disable auto take-up.
8 Manual switch
Use this switch to select the manual take-up direction. The selected option takes effect when the
Auto switch is in the Off position.
9 Casters
There are two casters on each leg. Once installation is complete, the front casters should be kept
locked while the printer is in use.
10 Airflow vents
These vents vent air from inside the printer. Do not obstruct these vents.
11 Waste ink bottle (tank) holder
Place the waste ink bottle in this holder.
12 Adjuster
The adjusters keep the printer in place. After installing the printer, keep it securely in place during
use.
13 Waste ink bottle (tank)
Waste ink collects in this bottle.
Replace with a new waste ink bottle when the level approaches the line.
14 Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the waste ink bottle while
the printer is in use.
15 Ink cartridges
Install all ink cartridges into each slot.
16 Lock levers
Raise the levers to unlock the ink cartridges prior to removal. Lower the levers to lock the cartridges
in place after insertion.
17 Cartridge check lamp
This lamp lights when an ink cartridge error occurs.
On : An error occurred. Check the message on the control panel's screen.
Off : No error.
10
Introduction