Problem Solver; When A Message Is Displayed - Epson SC-S80600 Series User Manual

SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide

Problem Solver

When a Message is Displayed

If one of the following messages is displayed, read and follow the instructions below.
Messages
Prepare empty waste ink bottle.
Ink Cartridge Error
Ink cartridge cannot be recognized. Insert
again or replace ink cartridge.
Ink Cartridge Error
Ink cartridge cannot be detected. Insert
again or replace ink cartridge.
Ink Cartridge Error
Replace cleaning cartridge.
Ink Supply Unit Error
Ink supply unit cannot be recognized.
Re-insert or replace it.
Ink Supply Unit Error
Ink supply unit cannot be detected.
Re-insert or replace it.
Ink Supply Unit Error
Replace cleaning supply unit.
Ink Low
Warming Up...
Z Force to start printing.
Command Error
Check print settings on RIP.
Clogged nozzles detected.
Cleaning recommended.
Problem Solver
What to do
The Waste Ink Bottle is getting full. Ready a new Waste Ink Bottle.
"Options and Consumable Products" on page 123
U
❏
Remove and reinsert the ink cartridge. If the message persists, insert a new
ink cartridge (do not reinsert the ink cartridge that caused the error).
❏
Condensation may have formed inside the cartridge. Leave it at room
temperature for at least four hours before installing the cleaning cartridge.
"Notes on handling ink cartridges/ink supply units" on page 22
U
❏
Remove and reinsert the Cleaning Cartridge. If the message persists, insert a
new Cleaning Cartridge (do not reinsert the Cleaning Cartridge that caused
the error).
"Replacement procedure" on page 72
U
❏
Condensation may have formed inside the cartridge. Leave it at room
temperature for at least four hours before installing the cleaning cartridge.
❏
Pull out the tray and re-insert the ink supply unit. If the message persists, even
if the tray is loaded in the ink unit, replace the ink supply unit with a new one
(the ink supply unit may be defective).
❏
Condensation may have formed. Leave it at room temperature for at least 4
hours before re-installing the cleaning cartridge.
"Notes on handling ink cartridges/ink supply units" on page 22
U
❏
Pull out the tray and re-insert the cleaning ink supply unit. If the message
persists, even if the tray is loaded in the ink unit, replace the cleaning ink
supply unit with a new one (the cleaning ink supply unit may be defective).
"Replacement procedure" on page 81
U
❏
Condensation may have formed. Leave it at room temperature for at least 4
hours before re-installing the cleaning cartridge.
The ink is low. Prepare a new ink cartridge/ink supply unit.
"Options and Consumable Products" on page 123
U
One or more heaters is still being warmed to the specified temperature. To start
printing without waiting for the heater to warm up, press the Z button.
Press the W button and select Job Cancel. Check that the installed software RIP is
compatible with the printer.
Stop printing and perform head cleaning if you judge it necessary on inspecting
the print results.
"Head Cleaning" on page 86
U
115