Using The Self-Propel Drive; Shutting Off The Engine; Mulching The Grass Clippings - Hayter CODE610B Operator's Manual

Using the Self-Propel Drive

To operate the self-propel drive, squeeze the self-propel-drive bar (1) toward the handle and hold it. Figure
16.
Note: The machine has a fixed maximum speed of approximately 1.86 m/h.
To disengage the self-propel drive, release the self-propel lever.

Shutting off the Engine

To shut off the engine, release the blade-control bar.
Note: Disconnect and ground the spark-plug wire before you leave the machine to prevent someone from
accidently starting the engine.

Mulching the Grass Clippings

Warning: The blade is sharp; contacting the blade can result in serious personal injury.
• Ensure that the mulching plug is in place before you mulch the clippings.
• Never engage the blade without the mulching plug in place, the grass bag installed, or the rear door
down.
If the grass bag is on the machine, remove it; refer to Removing the Grass Bag (page 22).
1. Raise and hold up the rear door. Figure 17.
Figure 16
1. Self-propel-drive bar
1
Figure 17
1. Latch 2.
21
1
2
Mulching plug
EN