Starting The Engine - Hayter CODE610B Operator's Manual

Starting the Engine

Important: This machine comes with a rubber boot over the end of the spark plug. Ensure that the metal
loop on the end of the spark-plug wire (inside the rubber boot) is fastened securely on the metal tip on the
spark plug.
1. Press the primer bulb 3 to 5 times. Figure 14.
2. Hold the blade-control bar against the handle (Figure 15A).
3. Pull the recoil-start handle lightly until you feel resistance, then pull it sharply (Figure 15B). When the
engine starts, allow the rope to return to the handle slowly.
Figure 14
A
B
Figure 15
1. Blade-control bar
20
EN