After Operation; After Operation Safety; General Safety; Hauling Safety - Hayter CODE610B Operator's Manual

After Operation

After Operation Safety

General Safety

• Always shut off the machine, wait for all moving parts to stop, and allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
• Clean grass and debris from the machine to help prevent fires. Clean up oil or fuel spills.
• Never store the machine or fuel container where there is an open flame, spark, or pilot light, such as
on a water heater or on other appliances.

Hauling Safety

• Use care when loading or unloading the machine.
• Secure the machine from rolling.

Cleaning under the Machine

Service Interval: After each use or daily.
Warning: The machine may dislodge material from under the machine.
• Wear eye protection.
• Stay in the operating position (behind the handle) when the engine is running.
• Do not allow bystanders in the area.
For best results, clean the machine soon after you have completed mowing.
1. Move the machine onto a flat paved surface.
2. Shut off the engine and wait for all moving parts to stop before leaving the operating position.
3. Lower the machine to its lowest cutting-height setting. Refer to Adjusting the Cutting Height (page 18).
4. Wash out the area under the rear door where the clippings go from the housing to the grass bag.
Note: Wash out the area with the bag-on-demand in both the fully forward and fully rearward positions.
5. Attach a garden hose that is connected to a water supply to the easy-wash port (1). Figure 19.
6. Turn the water on.
1
Figure 19
1. Easy-wash port
24
EN