Adjustment Of Roller Unit (Alu-Profile) - probst TAS-UNI-450 Operating Instructions Manual

Installation and Operation
3.4

Adjustment of roller unit (Alu-Profile)

The working height of the device (TAS-UNI) can be adjusted
with the spindle (1).
•
Place the alu-profile direct on the facing bedding sand
(see fig.4).
•
Place the roller unit on the alu-profile.
•
Release the eyebolt (2).
•
Adjust the screeding profile on the crank (1) in that way,
that the screeding profile rests on the facing bedding
sand. Orientaion on the scale (3).
➔TIPP Optimal facing bedding sand (grit height) 2-3
cm.
•
Fasten eyebolt (2) again.
IMPORTANT ➔ ➔ ➔
Roller unit
Facing bedding sand
m
51000042/51000043
Facing bedding sand
Fig. 4
Alu-Profile
(1)
(2)
(3)
Fig. 3
Roller unit
Alu-Profile
Alu-Profile must rest on the
facing bedding sand.
12 / 16
Alu-Profile may not sink in the
facing bedding sand! 
GB