Adjustable Adapter For Roof-/Pan Profile; Adjustment Roof Profile - probst TAS-UNI-450 Operating Instructions Manual

Installation and Operation
3.2

Adjustable Adapter for Roof-/Pan Profile

•
With the adjustable adapter TAS-DP (2000 mm) any
roof or pan profile can be adjusted (+/- 4 % with scale)
to prepare any roof or pan profiles.
•
Screw the nuts on the inner side at the TAS-DP
slope (%) for roof profile→ Figure 2 (see also Figure A
on following page).
Screw the nuts on the outer side at the TAS-DP
slope (%) for pan profile→ Figure 3 (see also Figure B
on following page).
Figure 1
3.2.1

Adjustment roof profile

Loosen both nuts (2) on the outer side at the TAK-DP. → Figure 1
Adjust the slope (e.g. 1%) with the both nuts (3) on the inner side at the TAK-DP. → Figure 2
Slope (e.g. 1%) is viewable and adjustable on the scale (4) and indicator (5). → Figure 3
1 scale line on the scale (4)
The indicated slope (%) on the scale is only for orientation.
The actually slope (%) must be measured again unconditional on the facing bedding sand!
See Figure A und A1 on the following pages.
Figure 1
(2)
51000042/51000043
≙
≙
≙
0,5 % slope. → Figure 3
Adapter for roof-/and pan profile
Figure 2
Figure 2
(3)
(3)
8 / 16
Figure 3
Figure 3
(5)
(4)
GB