Installation and Operation
Meassure the outer dimension at the TAS-DP (1) with a qualified measuring tool (6) e.g. yard stick (or slide gauge).
These measure must be equal at the front side and back side (see ). → Figure 4 and Figure 5.
Tighten both nuts again (tight) on the outer side at the TAK-DP. → Figure 6
Figure 4
1%
Also a roof profile with different lengths of
aluminium profiles is preparable.
→ see Figure A1
3.2.2
Adjustment pan profile
Loosen both nuts (2) on the inner side at the TAS-DP. → Figure 7
Adjust the slope (e.g. 1%) with the both nuts (3) on the inner side at the TAS-DP. → Figure 8
Slope (e.g. 1%) is viewable and adjustable on the scale (4) and indicator (5). → Figure 9
1 scale line on the scale (4)
The indicated slope (%) on the scale is only for orientation.
The actually slope (%) must be measured again unconditional on the facing bedding sand!
See Figure B und B1 on the following pages.
51000042/51000043
(1)
(6)
Figure A (roof profile)
Remessure the actual
slope at the
bedding sand
1 %
≙
0,5 % slope. → Figure 9
Figure 5
(6)
Referenz plane
facing
Figure A1
9 / 16
Figure 6
1%
1 %
GB