Adjustments; Adjustment Of The Handel; Operation - probst KKV 8/14 Operating Instructions Manual

Adjustments

5 Adjustments
5.1

Adjustment of the handel

When the device is used in the 2-man operation, the handle can be
rotated about 90°.
•
Remove the locking pin of the plug bolt.
•
Remove the handle from the rectangle pipe and rotate it about
90 °.
•
Insert the plug bolt and secure it with the locking pin again.
Be careful when adjusting the handle - risk of injury to the hands!
6

Operation

•
Connect the device (KKV 8/14) as described in "Installation suspension lug" to the lifting device or use
it manual by 2-man operation (at the handles).
•
Move the device (KKV 8/14) in „Transport position" (Fig. 1) to the gripping good.
•
Position the device (KKV 8/14) centric over the gripping good (cable channel) and tilt the handle (a
little) to move the device into the "Operating position" (Fig. 2).
•
The device (KKV 8/14) can now be lifted with the gripping good (cable channel) → see Fig. 3
•
When setting down good gripping at the floor, the device opens automatically (now the device can be
replaced in the "Transport position" again (Fig. 1)).
„Transport position"
Fig. 1
Be careful when changing from transport to operatingposition (and inverse) - risk of injury to the
hands!
53100061
„Operating position"
Fig.. 2
12 / 16
Handle
Locking
pin
Plug bolt
„Device in use"
Fig. 3
GB