Table of Contents
Advertisement
320 Maintenance and care
320
Ensure there is su cient ground clear-
#
ance between the underbody and the
guide rails of the car wash.
Ensure that the clearance width of the
#
car wash, in particular the width of the
guide rails, is su cient.
To avoid damage to your vehicle when using a car
wash, ensure the following beforehand:
To avoid possible water ingress in the vehicle,
R
it is preferable to use car washes which allow
the high-pressure pre-cleaning to be deactiva-
ted (speci cation for the cabriolet program).
Avoid any hot-wax treatment.
R
Active Distance Assist DISTRONIC is deactiva-
R
ted.
The HOLD function is switched o .
R
The 360° Camera or the reversing camera is
R
switched o .
The side windows and so top are closed
R
completely.
The blower for the ventilation and heating is
R
switched o .
The windscreen wiper switch is in position g.
R
The key is at a minimum distance of 6 m away
R
from the vehicle. Otherwise the boot lid or a
door could open unintentionally.
For car washes with a conveyor system:
R
Neutral i is engaged.
-
The vehicle is locked from inside.
-
%
If, a er the car wash, you remove the wax
from the windscreen and wiper rubbers, this
will prevent smearing and reduce wiper noise.
Inf Infor ormation on using a high-pr
mation on using a high-pressur
essure cleaner
& W W ARNING
ARNING Risk of an accident when using
high-pressure cleaners with round-spray
nozzles
The water jet can cause externally invisible
damage.
Components damaged in this way may unex-
pectedly fail.
Do not use a high-pressure cleaner with
#
round-spray nozzles.
Have damaged tyres or chassis parts
#
replaced immediately.
To avoid damage to your vehicle, observe the fol-
lowing when using a high-pressure cleaner:
The key is at a minimum distance of 3 m away
R
from the vehicle. Otherwise the boot lid or a
door could open unintentionally.
Maintain a distance of at least 30 cm to the
R
vehicle.
e cleaner
V V ehicles wit
ehicles with decor
R
vehicle are covered with a decorative foil.
Maintain a distance of at least 70 cm between
the foil-covered parts of the vehicle and the
nozzle of the high-pressure cleaner. Move the
high-pressure cleaner nozzle around whilst
cleaning. The water temperature of the high-
pressure cleaner must not exceed 60°C.
Observe the information on the correct dis-
R
tance in the equipment manufacturer's opera-
tor manual.
h decorativ
ative f e foil:
oil: Parts of your
Advertisement
Table of Contents
