Table of Contents
Advertisement
176 Driving and parking
176
Engaging rev
Eng
aging rever erse g
se gear R
ear R
Depress the brake pedal and push the DIRECT
#
SELECT lever upwards past the rst point of
resistance.
Engaging neutr
Eng
aging neutral N
al N
Depress the brake pedal and push the DIRECT
#
SELECT lever up or down to the rst point of
resistance.
%
To shi into neutral i with the vehicle
switched on, push the selector lever up or
down for several seconds to the rst point of
resistance.
Subsequently releasing the brake pedal will allow
you to move the vehicle freely, e.g. to push it or
tow it away.
Pr Proceed as f
oceed as follow
ollows if y
s if you w
ou want t
ant the aut
tr transmission t
ansmission to r
o remain in neutr
emain in neutral al i
v v ehicle is switc
ehicle is switched
hed o o or t
or the dr
he driv iver's door is
opened:
opened:
Depress the brake pedal and engage neutral
#
i when the vehicle is at a standstill.
Release the brake pedal.
#
Switch o the vehicle.
#
The
Risk of vehicle rolling away N activated man-
ually No automatic switch to P
in the driver's display.
%
If you then exit the vehicle leaving the key in
the vehicle, the automatic transmission
remains in neutral i.
The park position j is automatically re-engaged
as soon as one of the following conditions is met:
you switch to transmission position h or k.
R
you press the button j.
R
Engaging par
Eng
aging park position P
Observe the notes on parking the vehicle
#
(
page 181).
/
Depress the brake pedal until the vehicle
#
comes to a standstill.
he automatic
omatic
When the vehicle is at a standstill, press but-
#
i , ev
, even if t
en if the he
ton j.
er's door is
When the transmission position display shows
j, the park position is engaged. If no trans-
mission position display j appears, secure
the vehicle to prevent it from rolling away.
%
Depending on the situation, it may take a
short time until j is engaged. Therefore,
message appears
k position P
always pay attention to the transmission posi-
tion display.
Park position j is engaged automatically if one
of the following conditions is met:
You switch the stationary vehicle o in trans-
R
mission position h or k.
You open the driver's door when the vehicle is
R
at a standstill or when driving at a very low
speed and the transmission position is h or
k.
When the vehicle is rolling, you switch if o in
R
transmission position h or k and bring it to
a standstill.
You switch o the engine, bring the vehicle to
R
a standstill and open the driver's door when
the vehicle is stationary or when the vehicle is
rolling and the transmission position is i.
Engaging park position j automatically is
R
required by the vehicle.
%
To manoeuvre with an open driver's door,
open the driver's door while at a standstill and
engage transmission position h or k again.
Advertisement
Table of Contents
