Table of Contents
Advertisement
184 Driving and parking
184
The vehicle is switched on.
R
The vehicle has not been started.
R
%
The garage door opener function is always
available when the vehicle is switched on.
Press and hold button 1,
2
#
wish to program.
Indicator lamp
4
ashes yellow.
%
It can take up to 20 seconds before the indi-
cator lamp ashes yellow.
Release the previously pressed button.
#
Indicator lamp
Point remote control
#
1 cm to 8 cm towards button 1,
Press and hold button
#
5
until one of the following signals appears:
Indicator lamp
R
ously. Programming is complete.
Indicator lamp
R
ming was successful. Additionally, syn-
chronisation of the rolling code with the
door system must be carried out.
If indicator lamp
#
green: repeat the procedure.
Release all of the buttons.
#
%
The remote control for the door drive is not
included in the scope of delivery of the garage
door opener.
or
3
that you
4
continues to ash yellow.
5
from a distance of
2
or 3.
6
of remote control
4
lights up green continu-
4
ashes green. Program-
4
does not light up or ash
Synchr hronising t
Sync
onising the r
he rolling code
olling code
R R eq equir uirements:
ements:
The door system uses a rolling code.
R
The vehicle must be within range of the garage
R
door or door drive.
The vehicle as well as persons and objects are
R
located outside the range of movement of the
door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 1,
#
or
3
repeatedly until the door closes.
When the door closes, programming is com-
pleted.
%
Please also read the operating instructions for
the door drive.
T T r r oubleshoo
oubleshooting when pr
ting when progr
ogramming t
amming the r
control ol
contr
Check if the transmitter frequency of remote
#
control
5
is supported.
2
he remote
emote
Advertisement
Table of Contents
