Chapter 5 Configuring and graphing chassis information
Table 46
describes the Boot tab fields.
Table 46 Boot tab fields
Field
SwVersion
LastBootConfigSource
LastRuntimeImageSource
LastRuntimeConfigSource
PrimaryImageSource
PrimaryConfigSource
SecondaryImageSource
SecondaryConfigSource
TertiaryImageSource
TertiaryConfigSource
EnableAutoBoot
EnableFactoryDefaults
EnableDebugMode
EnableHwWatchDogTimer
EnableRebootOnError
EnableTelnetServer
EnableRloginServer
EnableFtpServer
EnableTftpServer
EnableSshServer
Description
The software version that is currently running.
The boot configuration file used when the switch most
recently booted.
The run-time image that was loaded most recently.
The run-time configuration that was loaded most recently.
The primary image source file.
The primary configuration source file.
The secondary image source file.
The secondary configuration source file.
The tertiary image source file.
The tertiary configuration source file.
Enables the autoboot option.
When you apply power, the switch waits 5 seconds and
then boots. If this option is set to false, the boot process
stops at the Boot Monitor.
Enables factory defaults option.
Enables debug mode option.
Enables hardware watchdog timer option.
Enables reboot on error option.
Enables Telnet server option.
Enables Rlogin server option.
Enables FTP server option.
Enables TFTP server option.
Enables SSH server option.
Configuring Network Management
171