Nortel Passport 8600 Configuring page 210

210 Appendix A RMON alarm variables
Table 65 Alarm variables (continued)
Category Subcategory
MLT
314723-D Rev 01
Variable
icmpOutParmProbs.0
rcStatMltEther
AlignmentErrors
rcStatMltEtherFCS
Errors
rcStatMltEtherSingle
CollFrames
rcStatMltEtherMultiple
CollFrames
rcStatMltEtherSQETest
Error
rcStatMltEtherDeferred
Transmiss
rcStatMltEtherLate
Collisions
rcStatMltEther
ExcessiveCollis
rcStatMltEtherMac
TransmitError
Definition
The number of ICMP Out parameter problem
messages received.
The number of frames received on an MLT that are not
an integral number of octets in length but do not pass
the FCS check.
The number of frames received on an MLT that are an
integral number of octets in length but do not pass the
FCS check.
The number of successfully transmitted frames on a
particular MLT for which transmission is inhibited by
exactly one collision.
The number of successfully transmitted frames on a
particular MLT for which transmission is inhibited by
more than one collision.
A count of times that the SQE TEST ERROR
message is generated by the PLS sublayer for a
particular MLT.
A count of frames for which the first transmission
attempt on a particular MLT is delayed because the
medium is busy. The count represented by an
instance of this object.
The number of times that a late collision is detected
on a particular MLT later than 512 bit-times into the
transmission of a packet; 512 bit-times corresponds to
51.2 microseconds on a 10 Mb/s system.
The number of times that excessive collisions are
detected on a particular MLT later than 512 bit-times
into the transmission of a packet; 512 bit-times
corresponds to 51.2 microseconds on a 10 Mb/s
system.
A count of frames for which transmission on a
particular MLT fails due to an internal MAC sublayer
transmit error. A frame is only counted by an instance
of this object if it is not counted by the corresponding
instance of either the LateCollisions object, the
ExcessiveCollisions object, or the CarrierSenseErrors
object.