Table 19 Dvmrp Tab Fields - Nortel Passport 8600 Configuring

108 Chapter 4 Configuring and graphing ports
5
6
7
Table 19

Table 19 DVMRP tab fields

Field
LocalAddress
Enable
Metric
InterfaceType
DefaultListen
DefaultSupply
DefaultRouteMetric Sets the metric (number of hops for DVMRP) of the default
AdvertiseSelf
InPolicy
OutPolicy
314723-D Rev 01
Enter a metric (cost) in maximum number of hops for DVMRP; the range is 1
to 31.
A default value of 1 means local delivery only. You can use the metric value
to control the scope of the DVMRP routes.
Click Apply.
Click Close.
describes the DVMRP tab fields.
Description
When enabled, the server reply is sent as a broadcast back to
the end station. The default is disable.
Enables (check box selected) or disables (check box not
selected) DVMRP on the port.
Specifies the distance metric for this port, used to calculate
distance vectors. The range is 1 to 31 hops.
Sets the port type as passive or active.
Sets the port to listen (check box selected) or not listen (check
box not selected) for the default route.
Sets the port to supply (check box selected) or not supply (check
box not selected) only the default route.
route. The range is 1 to 31 hops.
Sets the port to advertise (check box selected) or not advertise
(check box not selected) local routes to neighbors.
Selects the name of the DVMRP accept policy applied to the
port.
Selects the name of the DVMRP announce policy applied to the
port.