Electro-Voice X-LINE ADVANCE Series Installation Manual page 56

56 en | Flying the system
Warning!
Do not lift an array by attaching directly to the sidearms. Lift with the supplied spreader
!
bar(s) only.
Failure to heed this warning may result in extensive property damage, serious injury or death.
Warning!
The spreader bar holes labeled PICK HERE and SAFETY HERE are not valid for any X12-125F
subwoofer array exceeding nine elements, even if two spreader bars are used. For arrays in
excess of nine elements, the two outer-most holes of the spreader bar must be used in a
!
bridled end pick configuration, regardless of whether one or two bars are being used.
Failure to heed this warning may result in extensive property damage, serious injury or death.
Consult the line array configuration software and follow all warnings, limitations, and
restrictions recommended by the software.
Caution!
When lifting a column of enclosures, make sure the correct dolly pins are released from the
dolly base. There are four dolly pins for each stack on the dolly base. (A total of eight pins on
!
the X12T-DOLLY base.)
If the column of enclosures is lifted with any of the dolly pins still locking the speakers to the
base, the dolly base will lift and tip. Property damage and personal injuries may occur.
To lift and fly an array directly from a dolly, do the following:
1.
2.
3.
4.
2019-07 | 04 | F.01U.310.953
If using the X12TC-GRID for X1 or X2, choose the forward or reversed orientation.
OR
If using the X12TE-GRID for X1 or X2, preassemble each sidearm with front and rear link
bars in the appropriate A, B, or C position.
OR
If using the X12-125F-GRID to fly X12-125F subwoofers, select forward or reverse
orientation and pre-assemble each sidearm with front and rear link bars in the
appropriate locations.
Pull and twist the four captive twist lock pins on the top element of the stack to be lifted.
Four captive twist lock pins are locked in the retracted (open) position.
Place one grid sidearm into the rigging bar channels of the first stack to be lifted and
engage both V-blocks on that side.
Twist the two captive twist lock pins (A) to engage.
Installation manual
X-LINE ADVANCE System Rigging & Transport
Electro-Voice