Stacking X1, X2, And X12-125F Elements Onto A Dolly - Electro-Voice X-LINE ADVANCE Series Installation Manual

X-LINE ADVANCE System Rigging & Transport
X1-212/90
X2-212/90
loudspeaker
X12-128
subwoofer
Figure 7.1: Transportation dolly options
7.1

Stacking X1, X2, and X12-125F elements onto a dolly

Caution!
We recommend that two or more persons lift and place heavier loudspeakers. Single person
!
lift and placement of heavier loudspeakers could cause injury.
Caution!
When lifting a column of enclosures, make sure the correct dolly pins are released from the
dolly base. There are four dolly pins for each stack on the dolly base. (A total of eight pins on
!
the X12T-DOLLY base.)
If the column of enclosures is lifted with any of the dolly pins still locking the speakers to the
base, the dolly base will lift and tip. Property damage and personal injuries may occur.
Notice!
Dolly wheel (the 4°) hole:
i
The bottom element to be landed on the dolly base must be pinned in the 4° hole ( ) in the
ANGLE SELECT section. Compress the rear link bars until they contact the angle select pin
and lock by adding a second pin in the EVEN holes of the ANGLE LOCK section.
Ensure the two front link bars are lowered and locked.
Electro-Voice
Dolly top (B)
or
Dolly transport base (A)
X12T-DOLLY
Dolly stacking
pocket (C)
Dolly top (B)
Dolly transport base (A)
X12-128-DOLLY
A Dolly transport base
C Dolly stacking pocket
E Dolly side panel
Dolly stacking
pocket (C)
Dolly side panel
X12-125F
bungie cords (D)
subwoofer
Dolly side panel (E)
Rachet strap (F)
B Dolly top
D Dolly side panel bungie cords
F Rachet strap
Installation manual
Transportation dollies | en
Dolly stacking
Dolly top (B)
pocket (C)
Dolly transport base (A)
X12-125F-DOLLY
2019-07 | 04 | F.01U.310.953
21