Table of Contents
Advertisement
22
en | Transportation dollies
Notice!
i
In this section, the rigging steps illustrated with X1/X2 full-range drawings are performed the
same way for the X12-125F subwoofer. Rigging differences between the X1/X2 full-range
elements and the X12-125F subwoofer are noted in the steps, when applicable.
To stack X1, X2, or X12-125F elements onto a dolly, do the following:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Guide the next element (E) onto the stack.
2019-07 | 04 | F.01U.310.953
Release the four dolly pins (A) on the dolly.
All four dolly lock pins are released and hanging from the dolly.
A
A
B
A
A
X12T-DOLLY
Extend and lock the two front link bars.
Extend and lock the two rear link bars at 4°.
Align the two front link bars over the V-blocks nearest the end of the dolly.
Guide the element (B) onto the dolly with the grille facing out.
Insert the four dolly pins (C) to lock the element onto the dolly.
Ensure the four dolly pins are secure.
D
D
D
C
C
C
X12T-DOLLY
Pull and twist the four captive twist lock pins (D).
All four captive twist lock pins should be in the retracted (open) position.
On the next element, extend and lock the two front link bars.
Extend and lock the two rear link bars at 0° EVEN.
F
F
E
F
X12T-DOLLY
A
A
X12-125F-DOLLY
D
D
D
C
X12-125F-DOLLY
F
Installation manual
X-LINE ADVANCE System Rigging & Transport
B
A
A
D
D
C
C
F
F
E
F
X12-125F-DOLLY
F
Electro-Voice
Advertisement
Table of Contents
