Electro-Voice X-LINE ADVANCE Series Installation Manual page 51

X-LINE ADVANCE System Rigging & Transport
8.
Compression method aiming using a pull-up to the grid
Using a X12TE-GRID and an X12PU-BGK to compress an X1 or X2 array or an X12-125F-GRID
and X12-125FPU-BGK to compress an X12-125F subwoofer array.
To pull-up to the X12TE-GRID or X12-125F-GRID, do the following:
1.
2.
3.
Electro-Voice
Assemble the second spreader bar of the bottom grid kit to the pull-up link bars installed
at the rear of the top grid.
This spreader bar must be installed upside-down, as described previously. Make sure all
quick-release pins are inserted completely through the side arm and securely locked in
position.
1 Front link bar
2 Rear link bar
3 Pull-up link bar and spreader bar
Using a 5/8-inch shackle rated for overhead lifting (A), attach the lever hoist (B) to the
spreader bar on the top grid (3).
Attach the load cell (C) to the bottom of the lever hoist (B).
Additional 5/8-inch shackles may be needed depending on the type of load cell used.
Attach the wire rope (D) to the bottom of the load cell (C).
Additional 5/8-inch shackles may be needed depending on the type of load cell used.
Installation manual
Flying the system | en 51
2019-07 | 04 | F.01U.310.953