Electro-Voice X-LINE ADVANCE Series Installation Manual page 44

44 en | Flying the system
Installing the X12TE-GRID to an X1 or X2 loudspeaker or the X12-125F-GRID to an X12-125F
subwoofer
Caution!
The extended grid sidearms are heavy and likely to tip if not secured, potentially causing
!
damage and/or personal injury if one should fall.
Always maintain a good grip on the sidearm until both twist-lock pins are fully engaged.
Caution!
Make sure that each end of each main grid spreader bar is pinned in the same number hole
!
on both main grid side arms.
Make sure the pins attaching the ends of each spreader bar to a side arm are fully inserted
and locked into the holes on both ends of each spreader bar.
Notice!
i
Before flying the array, make sure that all captive twist lock pins are fully engaged in the
rigging (no red showing between the pin knob and the element).
Notice!
i
In this section, the rigging steps illustrated with X1/X2 full-range drawings are performed the
same way for the X12-125F subwoofer. Rigging differences between the X1/X2 full-range
elements and the X12-125F subwoofer are noted in the steps, when applicable.
To install the X12TE-GRID or X12-125F-GRID, do the following:
1.
2.
3.
2019-07 | 04 | F.01U.310.953
Attach front link bars (A) to the side arms.
Consult the line array configuration software for the A, B, or C position of the front link
bars for the particular array being flown with X1 or X2 elements. Only one position is
available for the link bars on the X12-125F-GRID. If additional up angle is required when
using the X12-125F-GRID reverse the side arms.
B
B
A
A
X12TE-GRID
Insert the attached quick-release pins (B).
Verify all quick-release pins are inserted completely through the sidearm and securely
locked in position.
Attach rear link bars (C) to the side arms.
B
Installation manual
X-LINE ADVANCE System Rigging & Transport
A
A
X12-125F-GRID
B
Electro-Voice