Electro-Voice X-LINE ADVANCE Series Installation Manual page 23

X-LINE ADVANCE System Rigging & Transport
11. Release the four captive twist-lock pins (F).
12. Repeat steps 7-11 to add up to three X1 or X2's in a single column.
13. Rotate the dolly.
14. Repeat steps 1-11 to stack the second column.
Stacking a cardioid subwoofer array on the X12-125F-DOLLY
Warning!
During transportation of a cardioid subwoofer array it is recommended that two people
maneuver the loaded dolly. The combined weight of a cardioid subwoofer array on the dolly
!
will exceed 750lb (340 kg). It is possible for the array to tip over if the dolly is not handled
properly.
Disregarding this warning could result in major injury or possibly death.
To build a 3-element cardioid array of X12-125F subwoofers, do the following:
Bottom element
1.
2.
3.
4.
Electro-Voice
All four captive twist-lock pins should now be in the closed position. Ensure the element
is secure.
The next two steps apply to the X12T-DOLLY only.
Release the four dolly pins on the dolly.
All four dolly lock pins are released and hanging from the dolly.
Lift the front of the element.
Pull and twist one of the front captive twist lock pins on the bottom element.
The front link bar will extend.
Twist and lock the captive twist lock pin at the front of the element.
The captive twist lock pin at the front of the element should now be in the closed
position with the front link bar extended.
Installation manual
Transportation dollies | en
2019-07 | 04 | F.01U.310.953
23